Achieve Maximize Efficiency and Productivity with CTS Test and Reclaim Systems

Frequently Asked Questions

Click on question to reveal the answer.

View Other FAQs:
1. What is the difference between “actual cc/m”, cc/m, and “std cc/m?”
[View Answer]
This is some alt text
2. Should I use “actual cc/m” or “standard cc/m” (sccm)?
[View Answer]
This is some alt text
3. Why does a 15 micron hole cost so much? Is there a less expensive solution?
[View Answer]
This is some alt text
4. How can I use “Quik Test” to test parts faster without compromising the leak test quality?
[View Answer]
This is some alt text
5. How does the “Auto Cal” feature in CTS products benefit me?
[View Answer]
This is some alt text
6. How can I use the “Process Drift” feature in the majority of CTS products to help me increase my test quality?
[View Answer]
This is some alt text
7. How can I avoid exhausting the dirty air from my part through the leak test?
[View Answer]
This is some alt text
8. How can I leak test a liquid filled container when it has just a small amount of air inside?
[View Answer]
This is some alt text
9. How do you decide what is an acceptable leak rate specification?
[View Answer]
This is some alt text
10. How can I estimate my leak rate if I am currently performing a dunk tank test?
[View Answer]
This is some alt text
11. Is there a way to calculate the hole size for our leak test specification?
[View Answer]
This is some alt text
12. How does temperature change affect pressure decay and mass flow testing?
[View Answer]
This is some alt text
13. How does volume change affect pressure decay and mass flow testing?
[View Answer]
This is some alt text
14. How is the pressure decay to leak rate formula derived from the Ideal Gas Law?
[View Answer]
This is some alt text
15. What is "IP" or "Ingress Protection?"
[View Answer]
This is some alt text